If you are preparing for the FE Civil exam, the first number you want is the honest one: how many people like you pass it. NCEES publishes that number every year, split by whether it was the candidate's first attempt and by the kind of degree they hold. This page collects the FE Civil figures from the last seven NCEES annual reports, shows how they compare with the other six disciplines, and explains what actually moves them.
Key statistic: In NCEES’s latest report (2024–25 exam year), 61% of first-time FE Civil takers passed (16,639 sat it for the first time). Among first-time takers with an EAC/ABET bachelor’s degree the rate was 64%; among other first-time takers, 53%; among the 314 with an ETAC/ABET engineering technology degree, 32%. Repeat takers passed at 32%.
The FE Civil pass rate in the latest NCEES report
Roughly 10,100 people passed FE Civil on their first attempt in a single exam year. That makes it the largest FE exam by volume: 16,639 of the 41,422 first-time FE takers that year, four in ten, sat FE Civil, and the pass rate is a population statistic over that whole group: graduates who prepared for three months and graduates who walked in cold, candidates sitting the exam in their senior year and candidates ten years out of school. The splits NCEES publishes are more useful than the headline, because they tell you which group you are in.
View the data as a table
| Taker group | Volume | Pass rate |
|---|---|---|
| First time, EAC/ABET bachelor’s degree | 12,256 | 64% |
| First time, all takers | 16,639 | 61% |
| First time, other takers | 4,069 | 53% |
| First time, ETAC/ABET bachelor’s degree | 314 | 32% |
| Repeat, all takers | 9,863 | 32% |
| Repeat, EAC/ABET bachelor’s degree | 7,275 | 34% |
| Repeat, other takers | 2,148 | 28% |
| Repeat, ETAC/ABET bachelor’s degree | 440 | 20% |
Two things in that chart matter more than the headline. First, the degree split: candidates from EAC/ABET-accredited engineering programs pass at 64%, other first-time takers at 53%, a gap of 11 points, and the 314 graduates of ETAC/ABET engineering technology programs who sat FE Civil for the first time passed at 32%. NCEES does not say why, and the “other” group mixes graduates of non-accredited and foreign programs with people who simply left the education field blank, so read the split as a signal about preparation and recency of coursework rather than a verdict on any degree. Second, the attempt split: repeat takers pass at 32%, 29 points below first-time takers, even though NCEES grades both to the same standard. The exam does not get harder the second time; the candidates who return are, on average, the ones whose first preparation did not work, and many of them return with the same preparation.
A third split is published for all FE disciplines together: timing. In NCEES’s 2025 report, first-time takers from ABET-accredited programs passed at 71.34% when they sat the exam before graduating and 70.62% within 12 months of graduating, against 63.43% when they waited a year or more (member boards only, data from 2014 to 2025). The full table is on the FE exam pass rates page.
How FE Civil compares with the other disciplines
FE Civil ties Other Disciplines for the lowest first-time rate of the seven disciplines in the 2024–25 report, 61%: 8 points under Mechanical, 7 under Chemical, 6 under Environmental, 3 under Electrical and Computer and 1 under Industrial and Systems. It is also by far the largest FE exam, with 16,639 of the 41,422 first-time takers that year, four in ten.
View the data as a table
| FE Discipline | First-time, all takers | First-time, EAC/ABET degree | Repeat takers | First-time volume |
|---|---|---|---|---|
| FE Mechanical | 69% | 72% | 37% | 11,552 |
| FE Chemical | 68% | 69% | 35% | 1,873 |
| FE Environmental | 67% | 70% | 37% | 2,543 |
| FE Electrical and Computer | 64% | 67% | 31% | 5,882 |
| FE Industrial and Systems | 62% | 64% | 25% | 547 |
| FE Civil | 61% | 64% | 32% | 16,639 |
| FE Other Disciplines | 61% | 64% | 29% | 2,386 |
| All disciplines (weighted) | 64% | — | 33% | 41,422 |
Over the seven NCEES reports the order changes less than the numbers do: Chemical, Environmental and Mechanical have held three of the top four places every year, and Civil has finished in the bottom three every year. The full seven-discipline picture, with the first-time and repeat gap for every exam, is on the FE exam pass rates page; the other two large exams have pages of their own: the FE Mechanical pass-rate page and the FE Electrical pass-rate page.
Seven years of FE Civil pass rates
One report is a snapshot. Seven are a trend, and the trend for FE Civil is not flat. In the 2018–19 exam year 65% of first-time takers passed (67% with an EAC/ABET degree); in 2024–25 it was 61% (64%). The first-time rate peaked at 66% in 2019–20 and bottomed at 60% in 2021–22, 2022–23 and 2023–24. Repeat takers moved between 32% and 34% over the same period. Volume fell to 11,455 first-time takers in the 2019–20 year, when test centers closed for part of the spring, and reached 16,639 in 2024–25, the most of the seven years.
View the data as a table
| Exam year | First-time, all | First-time, EAC/ABET | Repeat | First-time volume |
|---|---|---|---|---|
| 2018–19 | 65% | 67% | 34% | 15,473 |
| 2019–20 | 66% | 69% | 33% | 11,455 |
| 2020–21 | 64% | 66% | 34% | 15,134 |
| 2021–22 | 60% | 62% | 32% | 13,666 |
| 2022–23 | 60% | 61% | 32% | 15,017 |
| 2023–24 | 60% | 63% | 33% | 15,619 |
| 2024–25 | 61% | 64% | 32% | 16,639 |
From the 2025 report on, NCEES prints graduates of ETAC/ABET engineering technology programs as a group of their own; earlier reports counted them among the other takers, so the other-takers line is not carried across years.
NCEES does not publish causes and this page will not invent one. Two facts sit inside the window, though. The current FE Civil specification took effect with the July 2020 examinations, so the earliest years were tested against a different set of knowledge areas. And NCEES sets the passing standard by subject-matter judgment, not by a target percentage of examinees: in its own words, it “scores each exam with no predetermined percentage of examinees that should pass or fail.” A lower pass rate therefore means the candidate pool is clearing a fixed bar less often, not that the bar was raised to fail more people.
What the pass rate does not tell you
Three things about NCEES scoring change how you should read every number above. The exam is reported as pass or fail only, with a diagnostic report by knowledge area for candidates who fail. The score is the count of correct answers, with no deduction for wrong ones and no partial credit on any item type, converted to a scaled score that adjusts for differences between forms; NCEES does not publish the passing score because it varies slightly with form difficulty, so “you need 70%” and similar rules of thumb have no official basis. And first-time and repeat takers are graded to exactly the same standard, which is why the repeat gap is a fact about preparation, not about the exam.
Where FE Civil candidates lose the exam
FE Civil is not lost on one hard topic. It is lost on breadth. The current NCEES specification has fourteen knowledge areas, and the four design areas carry the most weight: Water Resources and Environmental, Structural and Geotechnical Engineering at 10 to 15 questions each and Transportation at 9 to 14, between 39 and 59 of the 110 questions together. Behind them sits the engineering-science core most candidates last studied in their second year — Statics, Mechanics of Materials, Dynamics, Fluid Mechanics and Materials — with another 30 to 46. A candidate who is strong in structures and skips transportation and surveying is betting on which form they draw. The FE Civil exam topics guide lists all 14 areas with their question ranges and an order to study them in.
The second leak is arithmetic, not knowledge: kips mixed with pounds or feet with inches inside a moment, a unit weight of water in the wrong system, gauge pressure where absolute was needed, an interest factor read from the wrong column, a horizontal-curve relation used on a vertical curve, a Handbook equation applied outside the conditions printed beside it. None of these show up as a weak topic on the diagnostic report NCEES sends to candidates who fail; they show up as a score a few points short in areas the candidate thought were fine. Timed practice under exam conditions is the only place they surface before test day.
The repeat trap. 32% of FE Civil repeat takers pass. If you are retaking, change something concrete: a study plan built backwards from the exam date, timed practice by knowledge area instead of re-reading, and the Handbook open during every session so that finding a formula is no longer a search on exam day. Retaking with the same preparation is the most expensive way to get the same result, and NCEES allows one attempt per testing window and three in twelve months.
How to be on the right side of the number
- Find out which group you are in before you plan. Eight timed questions across the knowledge areas tell you more than any average: take the free FE Civil diagnostic and rank your weak areas.
- Size the effort from the NCEES ranges, not from fear. The FE Civil exam topics guide lists every knowledge area with its question range and an order to study them in.
- Plan backwards from the exam date and expect to miss sessions. The day-by-day planning guide shows how to build the calendar and what to do when a week goes wrong.
- Drill by knowledge area, under time, with the Handbook open. Start with the free FE Civil practice problems, each with a worked solution and the Handbook page behind it; put what you missed on flashcards.
- Take a full-length mock every two weeks from week four. 110 questions, 5 hours and 20 minutes, the break where NCEES puts it. The mocks are what tell you whether you have moved from the 53% group to the 64% group.
Prepare against the real specification
1,150+ FE Civil questions across every NCEES knowledge area, 14 written courses, a CBT simulator that runs the real clock with the scheduled break, an AI tutor for any problem, and analytics that show which areas are costing you points.
See the FE Civil PlatformConclusion
61 out of every 100 first-time FE Civil takers pass, 64 out of 100 when they come from an accredited engineering program, and 32 out of 100 when they are back for a second try. The number has drifted down over seven NCEES reports, from 65% to 61%, against a passing standard that NCEES fixes by judgment rather than by quota. None of that is a verdict on you. The groups that pass at the highest rates are the ones whose preparation was recent, structured and timed, and every one of those is a choice you can still make.
Sources: NCEES, Squared: A Year in Numbers, FE exam pass-rate tables in the 2019, 2020, 2021, 2022, 2023, 2024 and 2025 reports; NCEES, Examinee Guide (scoring, scaled scores, pass/fail reporting, attempt limits); NCEES, FE Civil exam specifications (effective July 2020); NCEES, FE exam.